0%
Addition Flow Exit wizard

Step 1: Add iErmu

Open the mobile client, and click "Add Camera" on the upper right corner to check if the iErmu camera is alternatively flashing in blue and red, and click "Blue and red indicators are alternated" .

Step 2: Reset the camera

In the selection of the configuration page, click on the option to “configure the scan code”. Standard version of the device, please use thimble light in hole configuration 5 seconds; fairy ball version of the device, please according to the configuration of the bottom of the camera button for 5 seconds, the camera to complete the reset.

Step 3: Scan code configuration

To ensure that the phone is in the link WiFi state, in the connection of the wireless web page, enter the phone connected to the WiFi password, please note that the connection to the WiFi 2.4G network. Scan the bar code on the back of the outer package or camera.

Step 4: Add iErmu device

Change the connected WiFi to WiFi prefixed with iErmu. After connection, return to the iErmu client where you can click "Phone WiFi Changed" and wait to scan the iErmu device. Select the iErmu camera to add, and click "Connect Now".

Step 1: Add iErmuios

Open the mobile client, and click "Add Camera" on the upper right corner to check if the iErmu camera is alternatively flashing in blue and red, and click "Blue and red indicators are alternated" .

Step 2: Input WiFi password

In the selection of the configuration page, click on the option to “use the acoustic mode configuration”. To ensure that the phone is in the link WiFi state, in the connection of the wireless web page, enter the phone connected to the WiFi password, please note that the connection to the WiFi 2.4G network.

Step 3: Add iErmu device

Increase the volume of your phone and get it close to the iErmu camera, click "Click to send audio" button. Wait to scan the iErmu device. Select the iErmu camera to add, and click "Connect Now".

Step 1: Add iErmu

Open the mobile client, and click "Add Camera" on the upper right corner to check if the iErmu camera is alternatively flashing in blue and red, and click "Blue and red indicators are alternated" .

Step 2: Manual configuration

On the WiFi password input page, click "Advanced" to enter the advanced configuration page where you can enable "Debug Mode", and manually set IP address, subnet mask, default gateway and router safety certification type. Click "OK", input the WiFi password, and click "Start Configuration".

Step 3: Add iErmu device

Change the connected WiFi to WiFi prefixed with iErmu. After connection, return to the iErmu client where you can click "Phone WiFi Changed" and wait to scan the iErmu device. Select the iErmu camera to add, and click "Connect Now".

After the iErmu camera is added, input the camera name and click "Check Now" to check the device added.

Reselect the mobile terminal type Return to the Help Center homepage

Step 1: Add iErmu

Open the mobile client, and click "Add Camera" on the upper right corner to check if the iErmu camera is alternatively flashing in blue and red, and click "Blue and red indicators are alternated" .

Step 2: Input WiFi password

In the selection of the configuration page, click on the option to “use the acoustic mode configuration”. To ensure that the phone is in the link WiFi state, in the connection of the wireless web page, enter the phone connected to the WiFi password, please note that the connection to the WiFi 2.4G network.

Step 3: Add iErmu device

Scan the iErmu device, and select the iErmu camera to add, and click "Connect Now".

Step 1: Start the device

Connect the data cable to the power adapter, and connect it to the power supply. In this case, the indicator on the iErmu is alternatively flashing in blue and red, indicating that the iErmu is started.

Step 2: Install iErmu mobile client

Use the "Scan QR code" feature of the WeChat to scan the QR code below to download and install the iErmu, and then log into or register the iErmu.